Hi, my name is

Anish Khot.

Designer. Builder. Engineer.

I’ve worked on and designed just about everything - from prosthetics and medical devices to woodworking and off-road race cars. Check out my work below!

About Me

I am a graduate student studying Biomedical Innovation and Development at Georgia Institute of Technology.

I have experience developing surgical instruments and implants for spinal surgery at Innovative Delta Technology. I have also been involved in neural engineering research at the APT Center, developing low-level impedance control and the mechanical structure of a powered prosthetic leg. I was also the Logistics Lead for CWRU Motorsports, where I mainly facilitate organization-wide management of equipment, tools, travel, vehicles, and other logistics for an design team of 80+ students.

In my projects, here are a few softwares I've been working with:
  • SOLIDWORKS
  • MATLAB
  • ANSYS
  • Vicon Nexus
  • CorelDRAW
  • Python
  • MasterCam

Projects

EBME 370/380 - Unobtrusive Ear-EEG for Long-Term Seizure Monitoring
EBME 370/380 - Unobtrusive Ear-EEG for Long-Term …
EBME 370 - First Iteration As a part of my senior project, my group designed a unobtrusive and …
EMAE 415 - Spinal Fusion FEA Study
EMAE 415 - Spinal Fusion FEA Study
Introduction As a part of my college curriculum, I had the chance to model the mechanical stresses …
OSL Bidirectional Neuroprosthesis
OSL Bidirectional Neuroprosthesis
Introduction Individuals with lower-limb loss often report diminished balance confidence and an …

Get in Touch

My inbox is always open. Whether you have a question or just want to say hi, I’ll do my best to get back to you!